Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| general [2014/09/11 11:51] – [General] rfile | general [2024/10/14 13:23] (current) – [General] rfile | ||
|---|---|---|---|
| Line 12: | Line 12: | ||
| [[general: | [[general: | ||
| + | |||
| + | |||
| + | [[general: | ||
| + | |||
| + | [[general: | ||
| + | |||
| + | [[programming: | ||
| + | |||
| + | [[general: | ||
| + | |||
| + | [[bike]] | ||
| + | |||
| + | |||
| + | [[https:// | ||
| + | ====== pump ====== | ||
| + | |||
| + | |||
| + | |||
| + | Sta rite | ||
| + | |||
| + | ALC-20F | ||
| + | |||
| + | J218-582APKG | ||
| + | |||
| + | 001G12U | ||
| + | |||
| + | A O Smith motor C48H2EC11C3 | ||
| + | |||
| + | 1/2 HP 3450 RPM | ||
| + | |||
| + | overload MET39AEM 28K2R | ||
| + | |||
| + | Wooten 583 2067 | ||
| + | |||
| + | |||
| + | <box 90% blue> | ||
| + | Get a piece of any old cheezy steel rod of suitable length, probably about 4 feet for your purposes. Pound a small flat like a spade drill on one end of it. Make darn sure the end is BLUNT, so it won't cut the pipe if you hit it. | ||
| + | |||
| + | Chuck it in your cordless drill (and take an extra battery), and start off down the path of the pipe. Every so often, drill a hole in the ground and see if you get mud on the blade or water coming out. | ||
| + | |||
| + | I've traced leaks and found the end of water-drilled holes etc with that method. Goes pretty fast, beats heck out of pounding and pulling, or digging. | ||
| + | |||
| + | I'll warn you that underground, | ||
| + | </ | ||
| + | |||